Spring Manufacturing Articles

Spring & Metal Form Technical Article


Proper Radii in Torsion Springs & Wire Forms

How important is it to use the proper bend radii when designing torsion springs and wire-forms? This is a topic that, when overlooked, can often result in excessive cost caused by breakage and therefore should be addressed prior to final design.

Breakage (fracture) will sometimes occur at the bends on torsion springs or wire forms when the radius is too tight (small). Higher concentrations of stress occur in these areas caused by the loads being applied to the sharp bends in the material.

Stress concentrations factors can be estimated. It is best, however, to design the radius to be 1.5 times the diameter of the material.

Please contact the Newcomb Spring facility nearest you for more information on designing torsion springs and wire forms with proper radii. Newcomb Spring also offers a special technical guide on CD that includes an animated glossary and information on spring characteristics. To request one of our technical cds visit our contact page - please write that you are requesting a CD in the Notes field.

 

<< Return to main articles page.

 

 

 

A Network of Newcomb Spring Facilities   •   Headquarters: 5408 Panola Industrial Blvd   •   Decatur, GA 30035
  •   770-981-2803   •  kando@newcombspring.com  •   © Newcomb Spring Corp.